Features & Advantages of lightweight aac wall floor panel
1. Lightweight: Aerated concrete density is usually 400-900
kg/m3(according to the market),
which is 1/3 of clay block and 1/5 of common concrete.
2. Fireproof: Most of the major raw materials is inorganic materials,
so it has good fire resistance,
and do not emit harmful gases when meet fire
3. Sound insulation: As the material inside has a large numbers of the
pores and porous, which
has a good thermal insulation properties.
4. Thermal Insulation: Thermal conductivity is 0.9-0.22 W/(MK), which
is 1/4 of clay bricks.
5. Anti-seismic: It can improve the two seismic than the brick level.
The hoist (Refer to the picture) is the back-up equipment for
autoclaved aerated concrete cutting machine. It is installed on the
automatic billet shift machine and the lifting is controlled by the
guide frame. It is an ideal choice for finished concrete
transportation, featured of stability, positioning-accuracy and no
The clamp is composed of a horizon beam, a vertical beam, a guide
frame, a guide device, clamp device, a lifting unit and cylinder
system. The two beams are made of huge steel pipes, so it is
featured of good stiffness, compact structure and it can be easily
installed and debug. Lifting device is located on the horizon beam
and the guide unit is fixed on the vertical beam.
The clamp can be moved, lifted, clamped and released.
It can be moved axially.
When pulley is hung by hanger, guiding device will move along the
guiding frame and then the hoist will go up and down.
Clamp and release
The hydraulic station supplies oil to the cylinder to make the
clamping device rotate, the cylinder contracts to clamp, and
elongate to release.
When the cylinder contracts and is in a clamped state, the spreader
is lifted, so the finished product can be lifted.
|Height||depends on the stroke|
Maintenance and repair
Pleas make sure that the cylinder system is maintained according to
its operation manual.
Please remove the dust on the piston rod after work with cotton
cloths and make sure it is reset.
To clean up the clamp unit, lifting device, guide unit and make
sure that there is no waste left.
Please check all fasteners to avoid any possible loose and change